insertion loss sentence in Hindi
Sentences
Mobile
- The theoretical insertion loss ( dB ) vs coupling ( dB ) for a dissipationless coupler is shown in the graph of figure 3 and the table below.
- Depending on these factors, the resulting insertion loss, along with the transmitted power and receiver sensitivity, will determine the maximum distance attained by such a system.
- The insertion loss is not such a problem for an unequal split of power : for instance at port 3 has an insertion loss less than at port 2.
- The insertion loss is not such a problem for an unequal split of power : for instance at port 3 has an insertion loss less than at port 2.
- Alternatives to fusion splicing include using optical fiber connectors or mechanical splices both of which have higher insertion losses, lower reliability and higher return losses than fusion splicing.
- The main parameters for selecting the proper type of LISN are impedance, insertion loss, voltage rating, current rating, number of power conductors and connector types.
- This can allow for some reduction in insertion losses ( depending on the concentricity accuracy of the ferrule ) by allowing the ferrule to be rotated to a more fortuitous alignment.
- The transmission quality of a network isolator can be determined by measuring the industry standard parameters or characteristics, for example, insertion loss, return loss, and near end crosstalk.
- Passive crossovers, like the driver units that they feed, have power handling limits, have insertion losses ( 10 % is often claimed ), and change the load seen by the amplifier.
- The resulting transmission function of the network has a passband ripple like the Chebyshev filter, but the ripples never reach 0dB insertion loss at any point in the passband, as they would do for the standard filter.
- TV modulators generally feature analog passthrough, meaning that they take input both from the device and from the usual antenna input, and the antenna input " passes through " to the TV, with minor insertion loss due to the added device.
- The switch matrix uses connectors or fixtures to route the signal paths from the sourcing and measurement equipment to the DUT . The switch matrix is typically located close to the DUT to shorten the signal paths, thus reducing insertion loss and signal degradation.
- Insertion loss is defined as a ratio of the signal level in a test configuration without the filter installed ( | " V " 1 | ) to the signal level with the filter installed ( | " V " 2 | ).
- It accomplishes this through a 7-row 16-wafer ( wafers can be power, differential or single-ended ) that delivers highly controlled impedance, minimal insertion loss and less than 3 % crosstalk at transfer rates up to 6.25 Gbit / s.
- Generally angle-polished connectors have higher insertion loss than good quality straight physical contact ones . " Ultra " quality connectors may achieve comparable back reflection to an angled connector when connected, but an angled connection maintains low back reflection even when the output end of the fiber is unmated.
- As the mechanical wave will propagate in both directions from the input IDT, half of the energy of the waveform will propagate across the delay line in the direction of the output IDT . In some devices, a mechanical absorber or reflector is added between the IDTs and the edges of the substrate to prevent interference patterns or reduce insertion losses, respectively.
- The 8.8 m diameter parabolic antenna, using a Cassegrain antenna feed, had a 0.4?beamwidth and a gain of 51 dB . Its monopulse, 5 horn feed system permitted the reference and error antenna patterns to have their gains independently established as well as the slope of the error patterns optimized while supplying target return signals to the receiving system with a minimum of insertion loss.
- More Sentences: 1 2
insertion loss sentences in Hindi. What are the example sentences for insertion loss? insertion loss English meaning, translation, pronunciation, synonyms and example sentences are provided by Hindlish.com.